|
A flat-6 or horizontally opposed-6 is a flat engine with six cylinders arranged horizontally in two banks of three cylinders on each side of a central crankcase. This should not be confused with the Opposed-piston engine. The pistons are mounted to the crankshaft such that opposing pistons move back and forth in opposite directions at the same time, somewhat like a boxing competitor punching their gloves together before a fight, which has led to it being referred to as a boxer engine. The configuration results in inherently good balance of the reciprocating parts, a low center of gravity, and a very short engine length. The layout also lends itself to effective air cooling. The shape of the engine suits it better for rear engine and mid-engine designs, where the low center of gravity is an advantage; in front engine designs the width interferes with the ability of the front wheels to steer. However, it is an intrinsically expensive design to manufacture, and somewhat too wide for compact automobile engine compartments, which makes it more suitable for luxury sports cars, cruising motorcycles, and aircraft. Only a few auto makers, including Porsche and Subaru, currently use horizontally opposed engines. Porsche continues to be the most prominent manufacturer of flat-6 engine luxury sports cars, while Subaru uses it in its all-wheel drive cars, where the difficulties of fitting the engine between the front wheels are offset by the efficiency of adding four-wheel drive to the layout. In the past a number of other manufacturers have used them, notably Preston Tucker in the 1948 Tucker Sedan and Chevrolet in the 1960s Corvair with flat-6 air-cooled engines. The Citroen DS was originally intended to be fitted with an air-cooled flat-6, but this never materialised. == Balance and smoothness == The movement of the pistons in a horizontal engine is all in the same plane, so it creates less vibration than in a V-configuration engine; particularly one, like a V6, with an odd number of cylinders on each side of the engine. Unlike the V6 but like the inline-6, the flat-6 is a fully balanced configuration which is in perfect primary and secondary balance. The three cylinders on each side of the crankcase tend to have an end-to-end rocking motion, like a pair of inline-triple engines, but in the usual boxer engine configuration, the imbalances on each side cancel each other, resulting in a perfectly smooth engine. The flat-6 is also smoother than the flat-4 or inline-4 because the power strokes of the cylinders overlap in a four-stroke cycle engine. In these four-cylinder configurations, pistons are 180 degrees apart in crankshaft rotation and start their power strokes every 180 degrees, so each piston must come to a complete stop before the next one commences its power stroke. In the flat-6, each power stroke begins 120 degrees after the previous one starts, resulting in 60 degrees of overlap between power strokes and a much smoother delivery of power to the flywheel. 抄文引用元・出典: フリー百科事典『 ウィキペディア（Wikipedia）』 ■ウィキペディアで「Flat-six engine」の詳細全文を読む スポンサード リンク
|